Port St. Lucie Tankless Water Heater logo
White outdoor tankless water heater mounted on a sand-colored stucco house wall with copper water lines and a gas line running down beside a palm

Tankless water heater in Port St. Lucie, FL

Hot Water Recirculation Pump Installation in Port St. Lucie, FL

  • Retrofit cost: HomeServe's national guide puts a pump that returns water through the existing cold line at $500 to $1,500 installed; a dedicated return loop runs $2,000 to $7,000.
  • Pump alone: $200 to $750 (HomeServe).
  • Minimum flow: Rinnai's RL75i and RL94i indoor units need 0.4 GPM through the heater before the burner lights.
  • Code control: Florida's 2023 plumbing code requires a crossover-style system to run on demand and to keep water entering the cold pipe at 104°F or below.
  • Pipe length: under the same code, no fixture may sit more than 50 feet of developed pipe from its hot water source, and a recirculating line counts as a source.

A local quote can land well away from these national numbers, mostly on how far a return line has to run. Port St. Lucie Tankless Water Heater, a free referral line, relays your request to an independent plumbing contractor for the pump fitting. Tell us the heater model, how far the farthest bathroom sits from it, and whether that sink cabinet has a power outlet.

Recirculation Setups for a Tankless Heater

A recirculation system moves the cooled water out of the hot pipe before you open the tap, so hot water arrives sooner. With a tankless heater there's a second reason. Rinnai's manual lists 0.4 GPM as the smallest flow its RL75i and RL94i indoor units will heat; trickle a tap below it and the water goes cold. Turn a tap off and back on within seconds, and Rinnai describes a 3-5 second activation lag that sends a slug of cold water down the line, the effect makers call the cold-water sandwich.

Small recirculation pump and crossover valve connected to the hot and cold supply lines inside a bathroom vanity

Crossover-Valve Pumps for Single-Story Homes

In a single-story house with the heater in the garage and the main bathroom at the far end, a new return pipe means opening walls. The usual retrofit borrows the cold pipe as the path home for cooled water. This Old House describes the kit: a pump at the farthest sink and a crossover valve between hot and cold, with a bimetallic part that lets water through once the hot line has cooled. A sensor stops the pump when hot water arrives, so the cold tap isn't left running warm.

  • Retrofit through the cold line, installed: $500 to $1,500 (HomeServe)
  • Angi's figure quoted by This Old House for a recirculating system: $200 to $400
  • Florida code for this type: demand control only, water into the cold pipe capped at 104°F
  • Needs an outlet under or near the sink for the pump
Insulated hot water return pipe running along a garage wall back to a tankless water heater

Return-Line Loops

A dedicated return pipe carries cooled water from the last fixture back to the heater, so the cold line stays cold. This Old House calls these full systems and suggests them for new builds and remodels where walls are already open. Rinnai's indoor manual cuts its warranty to 3 years when the heater runs in a circulation loop without on-demand control, and a timer on a standard pump doesn't count as on-demand.

  • Dedicated loop, installed: $2,000 to $7,000 (HomeServe)
  • Good fit: a remodel with open walls or attic access to the far bathrooms
Condensing tankless water heater with its front cover open showing a small built-in circulating pump

Heaters That Ship with an Internal Pump

Some tankless models come with a pump already built in. Navien's NPE-A2 series combines an internal pump and a buffer tank, which Navien says deals with both the cold-water sandwich and low-flow shutoffs. It can circulate through a return line or, with Navien's NaviCirc valve under a far sink, through the existing supply lines. If you're replacing the heater anyway, pricing one of these against a separate pump is worth a line on the quote.

  • No separate pump on the wall
  • NaviCirc valve: for houses with no dedicated return line
Small push button mounted on the side of a bathroom vanity cabinet beside the sink

Push-Button and Scheduled Runs

How the pump starts decides how much it costs to run. This Old House shows a button drilled into the side of the vanity, and points to timers that run the pump only at busy times. It also warns that a badly controlled loop can waste energy rather than save it. For the crossover type, Florida's code already requires a start signal from a person: a button, a sensor that detects someone at the fixture, or flow at a tap.

  • Push button: one press before a shower
  • Timer: morning and evening windows (on a loop through a Rinnai heater, a timer alone shortens the warranty)
  • Motion or flow sensing: starts when someone is at the fixture
Gloved hands tightening a brass service valve under a white wall-mounted tankless water heater in a garage

Why Port St. Lucie homeowners and businesses call Port St. Lucie Tankless Water Heater

  • Sending a request is free and doesn't commit you to anything
  • Your details go to one licensed plumber, never a list of callers
  • Ask for the unit's flow rate at your water temperature in writing
  • Ask who files the city permit and books the inspection
  • The referral adds nothing to the plumber's price

Get a free tankless water heater estimate

Free for homeowners and businesses. One local contractor contacts you.

Before You Approve a Recirculation Quote

A pump fixes waiting time. If hot water drops out in the middle of a shower, the cause may be low flow or a fault in the heater itself; the tankless repair page covers those. A heater that's too small for the house won't be helped by a pump either; see sizing.

Ask for these in writing:

  • System type

    Crossover through the cold line, dedicated return, or the heater's own pump.
  • Controls

    Button, timer or sensor, and the 104°F limit on crossover water.
  • Power

    Where the pump plugs in, and whether a new outlet is part of the price.

Ready to get started in Port St. Lucie?

Tell us about the job and a local tankless water heater contractor will get back to you with a free estimate.

Get a free tankless water heater estimate

Free for homeowners and businesses. One local contractor contacts you.