Tankless Water Heater Repair by Symptom
Most service calls start with one of five complaints. Each points to a different part of the heater, and knowing which one you have helps the plumber bring the right parts. Brand names below are spec sources only, not a claim of factory service.

Cold Taps or a Unit That Won't Fire
If nothing happens when a hot tap opens, Rinnai's manual starts with the simple checks: power and gas on, the cold-water inlet filter clean, and enough flow to reach the minimum. On a new install, swapped hot and cold lines can cause the same symptom. If the burner tries and fails, Rinnai's checklist for its no-ignition code runs through gas pressure and gas type, whether the line, meter or regulator is too small, and the igniter itself. A power outage also stops gas models, since they run on 120 volts (power outages).
- Igniter repair: $75 to $350 (HomeGuide)

Flashing Codes on the Controller
A tankless heater watches its own operation and flashes a code when something fails, and that code is the quickest route to the fault. Rinnai's manual asks owners to quote it when they call for service. On that brand, 10 points to a blocked air intake or exhaust, 11 to no ignition, 12 to a flame that went out, and LC to scale in the heat exchanger. With LC the heater still makes hot water, but the readout flips between those two letters and the temperature while the controller beeps. Its MC-91 controller can replay the last nine codes. Write them down before anyone resets the unit.

Drips Under the Unit or at the Valves
A drip at a union or service valve is often a fitting repair. Water from the relief valve's discharge pipe is a pressure question first: is the valve worn, or is the house pressure spiking when water heats? That second case is where thermal expansion control comes in. Rinnai's manual requires an approved pressure relief valve on its heaters and recommends working it by hand once a year. Water from inside the cabinet needs a technician's look; the costliest line in HomeGuide's tankless repair table is a heat exchanger replacement.
- Leak repairs: $100 to $1,000; relief valve replacement $50 to $300 (HomeGuide)
- Heat exchanger: $1,200 to $1,300 installed, or $600 to $700 labor when the part is under warranty
- Typical warranty, per HomeGuide: labor 1 year, parts 5 to 12 years, varying by brand

Hot-Cold-Hot Swings in the Shower
Temperature swings have two common causes, and only one is a fault. A short cold burst after a tap is shut and quickly reopened has its own explanation and fixes, covered on the recirculation pump page. Swings that follow the tap setting usually mean the flow is falling below the heater's minimum. Rinnai's manual says turning a tap down can do it, and suggests a set temperature closer to what you actually use, so less cold water gets mixed in. Swings at full flow on a unit that used to be steady deserve a visit.

Breaker Trips on Electric Models
An electric whole-house unit runs on two or three heavy double-pole breakers, three 40-amp breakers for an EcoSmart ECO 27. If one trips over and over, stop resetting it. HomeGuide's advice for a heater that keeps tripping its breaker is to call a residential electrician, because the cause may be wiring rather than the heater. Ask whether the plumber works with an electrician who can check both sides in one visit (breaker and amp load).

Why Port St. Lucie homeowners and businesses call Port St. Lucie Tankless Water Heater
- Sending a request is free and doesn't commit you to anything
- Your details go to one licensed plumber, never a list of callers
- Ask for the unit's flow rate at your water temperature in writing
- Ask who files the city permit and books the inspection
- The referral adds nothing to the plumber's price
Tankless Repair Cost and the Replace-or-Fix Point
HomeGuide's national figures put most tankless repairs between $300 and $1,300. A fault caught early, a dirty inlet filter or a worn igniter, sits at the low end. A cracked heat exchanger on an older unit sits at the top.
Before agreeing to a big repair, put three numbers side by side: the repair quote, the unit's age, and the price of a new installed unit. HomeGuide suggests replacing once a heater passes 10 years or the fix costs more than half of a new one. Replacement prices and how long units last are on the replacement page. If the fault was scale, the yearly flush is what stops it coming back, and Rinnai's manual says its warranty doesn't cover scale damage.
Notes That Shorten the Repair Visit
A plumber who knows the model and the fault before arriving can bring the likely part on the first trip. Gather these:
The code
Exactly as shown, and whether it returns after the unit is switched off and on.Model and serial number
From the label on the side of the cabinet.Fuel
Natural gas, propane or electric, and whether anything on that supply changed recently.Age and flush history
The install year and the date of the last descale, if anyone knows it.Photos
A phone picture of the display and of the pipes and valves under the unit.What happened
Every tap or only one, all day or only at certain times, and any noise, smell or water on the floor.
