Where a Small Tankless Unit Earns Its Place
A point-of-use heater serves one fixture, or two at most, from a box small enough to hide in a cabinet. Port St. Lucie's warm tap water helps these little units, since a modest rise reaches shower temperature (see sizing for warm inlet water). The four placements below are where they make the most sense.

Under-Sink Units for a Far Kitchen or Bath
When one sink sits at the far end of a long single-story house, a heater in the cabinet below it cuts out the wait for water to travel from the garage. EcoSmart's POU 3.5 is sized for one low-flow faucet and ships with 0.35 GPM aerators; Stiebel Eltron's DHC-E 8/10 lifts water about 49 to 66 degrees at one gallon a minute, depending on its setting. A recirculation pump is the other fix for a slow tap; see recirculation pumps to compare.
- EcoSmart POU 3.5: 7 x 11 x 3 inches, 4 pounds, half-inch connections, mounted upright
- Stiebel Eltron DHC-E 8/10: 30 or 40 amps at 240 volts, 10 or 8 AWG wire
- Water supply: at least 25 to 30 psi, per the two spec sheets

Electric Units Dedicated to One Shower
A shower needs more flow than a sink, so a single-shower unit is a step up in size. Stiebel Eltron's Tempra 15 raises water 43 degrees at 2.25 gallons a minute. Starting from about 72°F, that works out to roughly 115°F at the head, comfortably above a 105°F shower mix. The smaller Tempra 12 gives a 36-degree rise at that flow. Both still want real panel capacity.
- Tempra 12: one 50-amp double-pole breaker, 8/2 AWG wire
- Tempra 15: two 30-amp breakers, two runs of 10/2 AWG
- Recommended main service: at least 100 amps for either
- Minimum flow to fire: 0.37 GPM (Tempra 12), 0.50 GPM (Tempra 15)

Pool Bath and Outdoor Shower Units
A pool bath on the far side of the lanai is another good candidate. EcoSmart says its 240-volt POU 6 handles one bathroom faucet or two low-flow faucets at once, which suits a pool-bath sink rather than a shower. For a rinse-off shower, use the single-shower sizing above. Before choosing a spot outdoors, ask whether the model is listed for a damp or outdoor location. Neither spec sheet quoted on this page says so.
- POU 6: 240 V, 6.5 kW, one 30-amp double-pole breaker
- Pool-bath shower: size it like the single-shower units above
- Outdoor mounting: confirm the listing first

Garage Utility Sink and Wet Bar Units
EcoSmart names wet bars and office breakrooms as typical spots for its point-of-use units, and a garage utility sink fits the same pattern. For a single bar sink, the 120-volt POU 3.5 is enough. A deep utility sink that fills a bucket benefits from Stiebel Eltron's DHC-E 12: a 54-degree rise at 1.5 GPM, but on a 50-amp breaker.
- Bar sink: POU 3.5, 120 V, one 30-amp single-pole breaker
- Utility sink: DHC-E 12, 240 V, 50-amp breaker, 8 AWG wire
- Temperature: EcoSmart's dial range is 80°F to 140°F

Why Port St. Lucie homeowners and businesses call Port St. Lucie Tankless Water Heater
- Sending a request is free and doesn't commit you to anything
- Your details go to one licensed plumber, never a list of callers
- Ask for the unit's flow rate at your water temperature in writing
- Ask who files the city permit and books the inspection
- The referral adds nothing to the plumber's price
What a Single-Fixture Heater Costs to Add Here
The unit is the cheap part. HomeGuide puts one at $150 to $250, Angi at $100 to $300, and This Old House's point-of-use bracket, 1 to 2 GPM, at $150 to $500. The circuit is what moves the price: HomeGuide gives $250 to $900 for a new dedicated circuit, and the panel needs a free slot or two for it. Florida's statute has plumbing contractors subcontract work that belongs to another trade, so ask whether the plumber's quote includes the electrician or leaves that to you.
Census figures show most Port St. Lucie homes heat with electricity, so an electric point-of-use unit rarely needs anything new beyond the circuit. It adds hot water at one tap and doesn't replace the main heater. If the whole house is short on hot water, look at tankless replacement or electric tankless instead.
